TenTec
[Top] [All Lists]

Re: [TenTec] Centurion issue.

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Centurion issue.
From: Mike Schatzberg <cherokeehillfarm@earthlink.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 11 May 2014 10:43:05 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Gliptal coatings can withstand up to 1500 volts per mil of coating. 

73,

Mike
W2AJI 

Sent from my iPhone

> On May 11, 2014, at 9:55 AM, P C A <xtraham58@hotmail.com> wrote:
> 
> I goofed big time. In a hurry I clicked on a spot on my logging program, the 
> Orion switched as it should. the Amp was already on that band, but the 
> antenna was not. Anyway, I arched over the Tune Cap. I found the bad spot and 
> used pattern files to smooth the burs out and polished the area with Scotch 
> Brite. From yrs of experience I knew at best this would be temporary and it 
> was. In the past I had some high voltage insulation, I think it was called 
> Gliptol???? It worked in some cases.Any Ideas before I buy a new Capacitor 
> from TenTec.Tnx Andy,W3LI                         
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>