The tricky part is soldering the correct length of the copper wire
crimped-soldered to the the PP inner part and implement that soldered
end on the board at the exact length, so the outer PP connector housing
seats flat.
If you are not experienced in soldering/tooling, get some help.
73 Mark, PA5MW
Look at:
https://www.flickr.com/photos/pa5mw/11384683803/in/photostream/
https://www.flickr.com/photos/pa5mw/11384552076/in/photostream/
https://www.flickr.com/photos/pa5mw/11384546215/in/photostream/
https://www.flickr.com/photos/pa5mw/11384683273/in/photostream/
https://www.flickr.com/photos/pa5mw/11384551726/in/photostream/
https://www.flickr.com/photos/pa5mw/8728473367/in/photostream/
I have also seen the Power-Pole modification Wiki. For those with some
history on that, how has that worked out for you? Can anybody offer a
parts list? I am a total newbie to Power-Pole connectors. Thanks in
advance for your efforts and information.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|