| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair II, PTO output level |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 25 Mar 2014 08:21:17 +0000 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
It was measured "in-situ" - so whatever load the following mixing stage
represents.
Steve G3TXQ On 25/03/2014 02:11, Jerry Haigwood wrote: Hi Steve, What was the load impedance? Jerry W5JH "building something without experimenting is just solder practice" _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] TT Argosy 525 F/S, possible trade, Allan Taylor |
|---|---|
| Next by Date: | Re: [TenTec] Corsair II, PTO output level, Doug Reid |
| Previous by Thread: | Re: [TenTec] Corsair II, PTO output level, Jerry Haigwood |
| Next by Thread: | Re: [TenTec] Corsair II, PTO output level, Doug Reid |
| Indexes: | [Date] [Thread] [Top] [All Lists] |