Well gang,
It’s great being able to move again and once more I’m in the shack.
I did some interesting testing with my doublet.
here’s a recap
132 feet on each side fed with 180 ish feet of 600 ohm open line. That goes to
an external 1:1 balun feed with three feet of LMR400 to the coupler.
A palstar coupler and the Ten Tec 238 coupler were unable to find a match.
So I added 15 feet to both ends.
No joy.
I added about 10 feet of wire inside the shack and strung it across the
ceiling. Looks like hell, but it’s up there
The palstar will find a solution at 1.890 now, but the swr is around 2.7:1
The 238, not so much. I did get it to tune, but the SWR slowly increased (I
plan on modifying the coupler with the high voltage doorknob caps)
Now, here’s the odd part.
I have a Ten Tec 253 AUTOMATIC tuner. That tuner found a solution for the 160
meter band from one end to the other.
Happy days!
But, using the same tuner, it can’t find a solution on 30 meters.
But the 238 and the palstar will tune it flat.
I don’t mind changing antennas, but swapping out couplers to operate from one
band to the other kinda sucks.
Mike WB8VGE
Knowledge is knowing a tomato is a fruit; Wisdom is not putting it in a fruit
salad.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|