If you don't, you will be reminded!
73,
Frank, K4VMO
----- Original Message -----
From: "Richards" <jrichards@k8jhr.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, October 16, 2013 7:13 PM
Subject: Re: [TenTec] Omni C + new Ham = Oops.
All good tips amounting to Axioms ... although you
left out the most important one, i.e., one must
remember which end is the handle. ;-)
--------------------- K8JHR ------------------
On 10/16/2013 8:04 PM, chacuff@cableone.net wrote:
Well as far as soldering there are a bunch more....
______________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|