Well... here is where I'm at:
Checked the 914 diodes on the SWR board and sensing diode (D1) was bad
(leaky reverse biased). A big smile.
I replaced the offending diode, put everything back together, attached a
dummy load to the output and turned up drive to see how much current was
drawn. I noted a 3 amps input power increase, and smoke. Smile goes away.
Tearing it back down I discover 3.3 ohm R5 and R8 have acquired deep tans.
These couple the impedance matching transformer to the bases of the power
transistors. A subsequent check verifies proper bias voltage to the final
stage.
Though toasty brown, and slated for replacement, R5 and R8 are still
correct values.
Unless I'm missing something major (always a possibility) I'm thinking that
this kinda seals the deal on the power transistors being bad.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|