| To: | Rick W <ve7tk@yahoo.ca>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Herc II Relay? |
| From: | Richards <jrichards@k8jhr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 14 Oct 2013 18:39:18 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Hmmm...
It started in the 60s with UNIVAC...
... then came the KILOVAC ...
.. and then came GIGAVAC...
... and now the Roomba-vac ;-)
No telling where will it end? ;-)
__________________ Anonymous ________________
On 10/14/2013 1:26 PM, Rick W wrote:
Thanks Jim. I found the Gigavac part and _______________________________________________ / _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Antenna is up, but the coupler doesn't like 160 meters, Mike Bryce |
|---|---|
| Next by Date: | Re: [TenTec] Omni C + new Ham = Oops., Mike Bryce |
| Previous by Thread: | Re: [TenTec] Herc II Relay?, Rick W |
| Next by Thread: | [TenTec] Interfacing MFJ-1026 with Argo V ?, Sherrell Greene |
| Indexes: | [Date] [Thread] [Top] [All Lists] |