TenTec
[Top] [All Lists]

Re: [TenTec] omni 6

To: ac5aa@ac5aa.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] omni 6
From: JOHN <ku3g@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 10 Oct 2013 13:30:06 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
THANKS DUANE , sorry for cps, i guess thats what i have to do but darn it one 
year ago and i cant remenmber
73
john
--------------------------------------------
On Thu, 10/10/13, Duane Calvin <ac5aa1@gmail.com> wrote:

 Subject: Re: [TenTec] omni 6
 To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
 Date: Thursday, October 10, 2013, 11:54 AM
 
 You can't key the Omni VI via the
 CI/V port.  I used to run a parallel port
 adapter (by W1??) that connected to the rear Key jack (I
 think I just
 dot-OR'd my keyer with the interface's lines).  
 
 Hope there's something here that helps.
 
     73, Duane
 
 Duane Calvin, AC5AA
 Austin, Texas
 www.ac5aa.com  
 
 
 
 
 -----Original Message-----
 From: TenTec [mailto:tentec-bounces@contesting.com]
 On Behalf Of JOHN
 Sent: Thursday, October 10, 2013 9:07 AM
 To: tentec@contesting.com
 Subject: [TenTec] omni 6
 
 good morning gang
    I have an omni 6 runing n3fjp softwave , i
 am using a w1gee interface
 from the computer to the ci/v jack on the rear of the omni ,
 control of the
 rig is fine, however i can not send cw , i am almost 99%
 sure i did this in
 the past , any ideas would be appreciated
 73 john ku3g
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>