I have not had this problem, but I'll bet $5 on the connector conductivity.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry N1EU
Sent: Thursday, October 03, 2013 5:49 PM
To: Orion565; Discussion of Ten-Tec Equipment
Subject: [TenTec] Dim LEDs on Orion front panel
The LEDs illuminating the ANT and VFO switch matrix are VERY dim,
essentially impossible to see. Before I tear into my Orion 565, I was
wondering if anybody else has previously troubleshot this exact issue.
I suspect either impaired connector conductivity or a bad cap. But has
anybody already done this deed and can report their findings?
Thanks & 73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|