TenTec
[Top] [All Lists]

Re: [TenTec] omni 6

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] omni 6
From: JOHN <ku3g@yahoo.com>
Reply-to: JOHN <ku3g@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 2 Oct 2013 04:18:08 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thanks , I just don't remember using anything else but the serial port for the 
logging 
73 john
ps where does that get connected in the rear of the omni
 

________________________________
 From: Barry N1EU <barry.n1eu@gmail.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com> 
Sent: Wednesday, October 2, 2013 6:05 AM
Subject: Re: [TenTec] omni 6
  

You need a keying interface between the computer and Omni that will
drive the key input of the Omni.  This is typically done with a COM
(or LPT) device or a WinKey keyer.

73, Barry N1EU

On Wed, Oct 2, 2013 at 9:58 AM, JOHN <ku3g@yahoo.com> wrote:
> Good . morning ,just got a used Omni 6 and am running n3fjp software.After 
> some intial problems the logging and spotting work great but I am having some 
> difficulty setting up the keying using the external keyboard and the 
> computer.  I had an Omni before and recall or I think I do that there was no 
> other connection from the computer
> to the rig , any help would be appreciated
> 73
> John KU3G
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>