Perhaps Carl is correct in that a Master Reset should be done. I agree, the
dropping of the first element should not take place. At present it does
not occur on the three current production Tentec radios on my desk.
Another clue regarding a suggested Master Reset is the version of firmware
being used. I would presume it was downloaded and installed and a Master
Reset was not done. Although not specifically required, I've found the when
changing firmware versions, I prefer to err on the side of "just do a Master
Reset" and start from scratch.
As you likely know I do a lot of beta testing thus I'm frequently loading
and reloading different versions of firmware. Thus I'm going back to
earlier versions and then to the version under evaluation for several
instances. In doing this, I find it very prudent to always implement a
Master Reset. It gives me a much clearer picture of what I'm experiencing.
I view this as no different than our computers when we perform a suggested
or recommended upgrade. We often see the message appear, "It is necessary
to restart the computer for the changes to take effect".
73
Bob, K4TAX
DISCLOSURE:
This is to inform all persons, I am a Tentec Ambassador and I receive
compensation according to the Tentec Ambassador program. In addition, I
serve as a volunteer beta test person to Tentec for the Omni VII, Eagle
and Argonaut VI radios. I hold no employment relationship, no financial
interests nor do I conduct any commercial business, direct or indirect,
with Tentec.
----- Original Message -----
From: "Jim Brown" <k9yc@audiosystemsgroup.com>
To: <tentec@contesting.com>
Sent: Saturday, September 21, 2013 2:44 PM
Subject: Re: [TenTec] The memory keyer in my Orion still cuts off the first
dash of the K at the front of my call. I've tried several suggestions but
none work. I'm running the 3.0X software. Any other thoughts?
On 9/21/2013 12:09 PM, Bob McGraw - K4TAX wrote:
I have had to add some characters in front of a data string to allow one
of the radios for another application to key up and start transmitting.
Now that being the case, as your configuration drops the first dash of
your call, why not add a "T" in front of your call. It would then drop
the "T" and send your call.
TK2XN. If the "T" is missing then K2XN would be legally transmitted.
There's a far better cure, and which Ten Tec has used since the Omni A.
The cure is to activate the PTT relay 8-10 msec before sending RF. In
other words, delay RF by 8-10 msec. As I recall, that pre-TX keying signal
is called the "T-line" in that older gear. In some newer Ten Tec gear you
have to go in and find it, then bring it out to the rear panel. I think I
had to do that in my Omni V. The delay is built into many other rigs,
like the TS-850, FT-1000-series, K2, and K3. In the FT1000-series and the
K3, the delay is adjustable via a menu. In the 850 and K2, it's fixed at
something like 8-10 msec. I've successfully used an 850, MP, and K3 to key
my Titan, Herc II, and Herc I (long ago sold). And it's even fast enough
to follow QSK up to about 25 wpm. At faster speeds the CW elements get too
short.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|