I'm running 3.0xxxa on my O II and do not have that problem.
Have you tried any of the various resets?
Kim N5OP
On 8/31/2013 1:18 PM, Mike Chatfield wrote:
I am running version 3.033xa just installed a couple of days ago. I
noticed an interested problem with the SAF.
If I leave SAF (Main Receiver) on and power down, then bring the Orion
II back on I get NO receive audio (mostly just popping noise) on the
Main receiver. In order to get the audio to work I must shut off SAF
then do a power cycle, it works fine then.
As long as I remember to shut off the SAF BEFORE powering off
everything works fine.
As anyone seen this issue?
Not a big deal but it looks like a firmware issue...
Mike
W0BBC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|