If there are two of them in parallel wouldn’t good practice be to replace them
both?
It that is the case something with a lower voltage than I suggested might be in
order..
Cecil Acuff
Gulfport MS
K5DL
From: Phil Chambley, Sr.
Sent: August 27, 2013 4:05 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Herc 2 LP Cap?
Those capacitors are a part of the shunt components in the low pass
filter network. They are not passing all of the current generated by
the amplifier. They are passing only that part of the harmonic energy
that makes it that far through the filter, and then only half of that,
since there are two of them in parallel. Without drowning in
arithmetic, I suggest that a good quality ceramic disc will probably be
adequate.
Phil C. Sr.
k4dpk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|