| To: | "tentec@contesting.com" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Delta 580 problem |
| From: | Peter & June Harband <flyingsub@att.net> |
| Reply-to: | Peter & June Harband <flyingsub@att.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 7 Aug 2013 00:39:20 -0700 (PDT) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The swr meter on my Delta doesn't function. I get correct alc action, but adjusting r3 that controls the swr calibration on the low pass filter board has no effect. c2 the swr zero control is functioning, and I can see changing the power output by tweaking it.The two diodes on the lp filter board check ok. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Argo V amp keying, Rsoifer |
|---|---|
| Next by Date: | Re: [TenTec] Argo V amp keying, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | [TenTec] Argonaut V receiver noise, doug hengel |
| Next by Thread: | [TenTec] VERY Subjective test of the Jupiter, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |