Re: [TenTec] OT: Openwire/Window Line and Bad Wx

[Steve Hunt <steve@karinya.net>]

Run any FF 3D plot and look at the Average Gain figure; it will tell you 
what fraction of the total input power is reaching the Far Field. If you 
set the wire losses to zero, you'll be left with just ground losses. AG 
is an efficiency figure, so 1-AG is the loss figure.
Steve G3TXQ





On 03/08/2013 21:51, k6jek wrote:
> Steve,
>
> Where are you getting losses out of EZNEC? I did re-run the the dipole at 25 
> and 55. As expected, all sorts of things are different. But where are you 
> reading losses?
>
> Jon
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec