Re: [TenTec] OMNI 6+ Alignment question

[Dennis R Baumgarte <ae2ee@rochester.rr.com>]

On 07/29/2013 05:50, Barry N1EU wrote:
> Don, agree with what Bob said - you need to first perform an accurate BFO
> oscillator alignment and then check the frequency of WWV.
>
> 73, Barry N1EU
>
> On Mon, Jul 29, 2013 at 2:57 AM, Don Rasmussen <wb8yqj@yahoo.com> wrote:
>
> > My frequency display is now reading 60hz high for a WWV zerobeat on USB
> > and LSB.
> >
> > Can anyone suggest if this would be the TCXO going out of tolerance or
> > possibly there is a trimmer?
> >
> > de wb8yqj/6
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
 Berry;

	Yes I do. Make sure you have the unit on for about 30 mins the do your 
calibration on the BFO; Then check it again after you cycle the radio on 
and off a few times. Rhen do a master calibration...

Dennis AE2EE

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec