TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec & Eagle

To: Roger Rippy <svtincup@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec & Eagle
From: CallSignsoftware/WA1EYP <mike@callsignsoftware.com>
Reply-to: mike@callsignsoftware.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 23 Jun 2013 11:49:16 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi Roger,

I have owned an Eagle for over a year and I can say the following:
-It has an extremely quiet receiver. Its RF gain works as it should and does not pump the AGC. -The DSP filtering along with the filters they provides beat anything I have owned including most TT rigs (but not Orion) -I have owned a K2 and found its audio very tiring. I have heard the same thing from friends that have upgraded to a K3. I chose not too. I demand audio that
my ears can stand for both SSB and CW.
-The DSP filtering and Pass band beat anything the K2 had to offer. I am not sure if they really improved this on the K3 or just
carried the K2 design forward.
-If you check Sherwood Engineering Site you are paying almost $900.00 extra for only a 5db improvement in the close in dynamic range.
-Finally TT service was a LOT better than Elecraft.


Mike WA1EYP

On 6/23/2013 9:47 AM, Roger Rippy wrote:
The purpose of this post is ask anyone who has had experiences with both the 
Eagle and the K3 to email me off-line with their opinions of both rigs. I say 
off line because I feel certain that this is a question and discussion that has 
taken place on more than one occasion. I have a K1 and Ten Tec Omni 6 Opt2 as 
well as a TT 540. My Omni 6 has gone on the fritz again this weekend and 
although I feel certain that TT service can fix it, I am at a point where I 
want to buy myself a new rig for CW use. I have always had used rigs with the 
exception of the K1 and I feel that it is time for one of the newer SDR rigs. I 
would certainly like to hear from you if you have operated both of these rigs 
extensively and would be able to take the time to tell me about those 
experiences. I have posted a similar request on the Elecraft reflector and have 
heard some well thought out opinions on these rigs; I would welcome yours. Of 
course I will probably send the Omni 6 in
  to service for a fix at some point unless I sell it since it too is a great 
rig. Thanks in advance. 73s Roger Rippy    W7RIP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




--
WA1EYP
www.callsignsoftware.com
Check out the Support Group on Yahoo for news on updates!!
http://groups.yahoo.com/group/CallSignSoftware-Support


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>