TO MODERATOR: Sorry for the previous sending goofs - my fat fingers at work.
I appologize .. Phil
Paul,
I've used bunches of A/D switches, both the 2 and 4 position. The only
times that I've seen failures were.
1. Hot switching - turning the switch with a lot of RF power applied.
2. Bad Pellet - check the breakdown voltage of the pellet. Chances are
the pellet is open (out of gas) and not protecting the contacts. I have
not had an A/D break except for physical (the knob was sheered off).
3. Arc over - a direct lightning strike when the contacts were fused
together and the coaxial cable (on the antenna side) melted. Note the
connected radio was NOT damaged.
73 de Phil - N8PS
-----
Quoting Paul DeWitte <k9ot@yousq.net>:
I have 2 Alpha Delta 4 position antenna switches that I use for 2
different radios. Both of these have failed in at least one position.
For those of you that use multiple position switches, what have you
found to work the best. I am not interested in remote electrically
switched ones. These switches are right at the operating position.
Thanks,73
Paul K9OT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|