The button used to select the "USB" mode is labeled "ATTN". It is a
multifunction button depending on what is on the display beside it. Its
normal function is to switch in attenuation. Does it work for this? If not
then it likely is a problem with the button itself (or as suggested, a
ribbon connector that serves this button). If it selects attenuation ok the
button is working correctly and there is a problem elsewhere.
73, Ted W4NZ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of N4BE_Jim
Sent: Sunday, June 02, 2013 9:40 PM
To: tentec@contesting.com
Subject: [TenTec] Orion II USB button not working
The USB mode selection suddenly stopped working. I can go into any other
mode but when I try to go back to USB it does nothing. Did clear and reset,
even loaded an earlier firmware version, nothing. I'm thinking maybe a bad
push button? Anyone ever had a similar problem?
Jim N4BE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|