Yes, my program supports up to 3 virtual comport pair hookups to allow
up to 3 different programs to hookup all at the same time. You would
use NaP3 with LPPan on virtual comport pair #1, FLdigi on pair #2, and
Winlog 32 on pair #3.
My software exports a Kenwood radio interface, so in FLdigi and Winlog
32, they would be configured for a Kenwood radio. And for NaP3 with
LPPan, configure NaP3 for a K3.
All this works very well together.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 5/14/2013 1:28 PM, Randy Moore wrote:
Question,
I have a Ten-Tec Eagle that I use with HRD version 6 so I can my LP-Pan
adapter, and all the features in HRD. I actually do not like HRD, it is
too big and bulky and bug-ridden.
I prefer to use FLdigi and Winlog 32 but then I have no LP-Pan or rig
control. So, if I buy your rig control program will I be able to run
Winlog 32, fldigi and the LP-Pan at the same time as your software.
Thanks,
Randy Moore
AI4CO
On 5/14/2013 7:28 AM, Carl Moreschi wrote:
I will be at Dayton in Booth 227.
I offer control software for the Tentec Pegasus, Jupiter, Omni VII,
Orion, Orion II, Eagle, Argonaut V, Argonaut VI, RX320, RX331, RX340,
and RX350.
Please stop by and say hello.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|