Bob -
For the sake of discussion; for a 1:1 UNUN at the "shack" end of an antenna
cable, is there an optimal location for Jim to put this UNUN?
I mean, will placing it right at the back of his amplifier out connector be
appropriate or outdoors, just outside of the shack?
Gene / K7TXO
----- Original Message -----
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 21, 2013 3:57 PM
Subject: Re: [TenTec] Built in SWR meter bannans
Sounds like RF current on the shield when on the antenna and not on the
dummy load. I suggest a 1:1 UNUN balun between the amp and the antenna.
I've had good success with a product from The Wireman being model #8232.
Certainly worth a try.
73
Bob, K4TAX
----- Original Message -----
From: "Jim GM" <jim.gmforum@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 21, 2013 11:13 AM
Subject: [TenTec] Built in SWR meter bannans
I have a Tec Tec Auto Coupler that is turned off and a Ten Tec Hercules II
at full power. The SWR bridges in side the equipment reads well over SWR
over 3:1 on certain bands while my BIRD Watt meter read 2:1.
ALL SWR meters is at 1:1 into a dummy load so that rules out the BIRD is
whacked.
This problem seams to mainly happen on 160M however I have seen it do
this
on different bands with other antennas in the past.
Are the diodes going into saturation? I am going BANNAS with this issue.
--
Jim K9TF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|