I would call Mouser/ or look online..Randy
--- On Thu, 4/11/13, Bob Good <k4bg@planters.net> wrote:
From: Bob Good <k4bg@planters.net>
Subject: [TenTec] Fw: Need Caps for Titan II Please
To: Tentec@contesting.com, "Amp Reflector" <Amps@contesting.com>
Date: Thursday, April 11, 2013, 9:53 AM
From: Bob Good
Sent: Tuesday, April 09, 2013 15:26
To: Tentec@contesting.com ; Amp Reflector
Subject: Need Caps for Titan II Please
I own a T-T Model 416 Titan II Amp and having a problem. It started with an
burning arc located at the bottom of the 160 / 80 Meter coil at the junction of
the 1/4 inch tubing coil. It carboned the bottom of the coil form. I removed
the one chassis mount and reconnected the two coils soldering the junction. I
have not a clue as to what caused the problem. All functional parameters
seemed fine. HV without RF drive, no arc. start applying power and buzzzzz
and stinky smoke. In the process of my clumsy attempt at repair I assume I
moved two of the ceramic loading caps to where they arced to the screw post on
the tuning variable cap resulting in another stinky arc which apparently cooked
the caps. When I cleared the caps by folding them back towards the PC board, I
have no arc but no output either. I hope the only damage is the two caps which
are C-6 and C-8 on the Load capacitor shunt board each 320 pf. A call to Paul
at T-T produced
no joy. They do not have the cap
s. Therefore.... does anyone have a couple of suitable caps I might purchase
or information as to where to go to find them? Any additional comments would
also be much appreciated. Thanks for reading and your help. (All info correct
on QRZ) Regards, Bob K4BG.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|