I second the recommendation.
Barry N1EU
On Mon, Mar 11, 2013 at 6:06 PM, Jerry Haigwood <jerry@w5jh.net> wrote:
> Curt,
> You might check with Glenn at DSMLabs.com. He does a lot of TenTec
> repairs and owns a lot of TenTec equipment. His phone number is on his web
> site.
> Jerry W5JH
> "building something without experimenting is just solder practice"
>
>
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Hulett,
> Russell
> Sent: Monday, March 11, 2013 12:27 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] Corsair II Receiver Tuneup?
>
> Having recently acquired a Corsair II ( after reading it's praise ), am
> thinking maybe it might benefit from knowledgable tech's checkout. The
> performance is ok and useful as-is, but I actually think my Omni C is
> better.
>
> I don't own much test equipment, so going through most of the procedures in
> the manual isn't appropriate. The only adjustments that might be possible
> are peaking of the two coils on the IF/AF amplifier board, but I'm
> reluctant
> to make adjustments without a scope.
>
> Short of sending the radio to Ten Tec, are there resources within Texas for
> checking out and optimizing a Corsair II?
>
> Thanks in advance and 73, Curt KB5JO
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|