Was that slot configured for 2.4 KHz or 6.0 KHz? If 6.0KHz, did you leave
the 2.4 KHz in the original slot and how was that slot configured?
I'd like more detail as to what filter is actually in F1, F2 and F3 slots
and how are they defined in the CONFIG menu.
Thanks
73
Bob, K4TAX
----- Original Message -----
From: "Rodney" <w3krq@dejazzd.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 11, 2013 12:21 PM
Subject: Re: [TenTec] eagle
I installed the filter in the am slot did a a/b test on 40m with 4 hams got
better audio with 2.8 than 2.4.
-----Original Message-----
From: Barry N1EU
Sent: Sunday, February 10, 2013 4:24 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] eagle
Is that filter is in the tx signal path of the Eagle? The tx signal isn't
filtered entirely in dsp with configurable bandwidth?
73,
Barry N1EU
On Sun, Feb 10, 2013 at 4:04 PM, Rodney <w3krq@dejazzd.com> wrote:
I got a 2.8 filter from inrad for my Eagle got great audio reports.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|