TenTec
[Top] [All Lists]

Re: [TenTec] Hercules 444

To: tentec@contesting.com
Subject: Re: [TenTec] Hercules 444
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Nov 2012 12:49:34 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 11/26/2012 10:29 AM, Jimmy O. Floyd wrote:
I have a Hercules 444 that is showing an I/V fault.

Hi Jimmy,

I sold my 444 several years ago, and hadn't used it for several years before that. BUT -- when I bought it, it was set for 120V and I re-wired it for 240V. It worked fine (although there was a wiring error I had to fix), but the higher line voltage improved the line voltage regulation, and as the power supply heated up, the 50V supply drifted upwards. One of the things that the power supply monitors is that 50V supply, and if it gets too high, protection kicks in.

At the time I ran into this (around 2004, I'd guess) someone sent me some ideas about how to do some circuit fixes. I didn't do them -- instead, I put a muffin fan on the power supply, which reduced the heating, and I had no issues after that.

I can only offer this as a possible clue. :)

Another thing that happens when rigs sit for a while is that electrolytic caps dry out and or short.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>