TenTec
[Top] [All Lists]

Re: [TenTec] Problem with Orion II and N1MM Logger

To: Rod Greene <w7zrc@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Problem with Orion II and N1MM Logger
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 18 Nov 2012 16:31:34 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Man... that would be totally aggravating.  \

I cannot explain what is causing it, but I think your description makes sense. At least that is a start.

Have you tried installing N1MM logger fresh - after saving all your special voice files in a separate backup directory, of course...?

I am a long-time software beta tester, used to seeing odd behavior from computer applications. In cases like this, I usually try a completely fresh install of the mother program, with all its default settings, and then make a new voice file or two (knowing my usual ones are safely saved in a backup folder...) to see whether that fixes the problem. Sometimes, when I cannot find a particular rogue setting, I just start over and it resolves the problem simply by returning the application to its default settings. Of course if that works, then you may never discover the root cause... but it might cure the problem and allow you to move on.

Just MY take, anyway... I don't think it will cost you anything to try it... ;-)

================= K8JHR ======================

On 11/17/2012 1:25 PM, Rod Greene wrote:
      something in Logger resets my
Mic gain setting on the Orion to zero. If I turn up the Mic gain setting
  while the .wav file is playing, the audio gets transmitted. Then when I
  click on a function key the next time, the Mic gain is set back to zero
  again. After the message plays, the Mic gain is restored to normal
level.

================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>