TenTec
[Top] [All Lists]

Re: [TenTec] OrionII and MixW Config settings

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OrionII and MixW Config settings
From: Stan Brock <sales@tentec.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 16 Nov 2012 13:35:20 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Bob,

I think for AFSK you want to be in LSB instead of USB.

Stan

On Thu, Nov 15, 2012 at 3:48 PM, Bob McGraw - K4TAX <RMcGraw@blomand.net>wrote:

> Tony:
>
> You mention FSK,  the MixW program provides AFSK and not a FSK signal
> although it says RTTY.  For AFSK the Orion should be in USB mode.  Check
> the value of the Line/Aux Gain as it may be 0 or too low.  Raise the
> Line/Aux gain to a mid way value to start.   Also the Windows Mixer will
> adjust the audio level going to the radio.
>
> From MixW drop down menu select Configure and then  Output volume.  This
> brings up the Windows Mixer.  The two sliders marked Volume Control and
> Wave are the controls for the audio out of the computer.   I normally run
> mine about mid range and then adjust the Wave slider for some 30 to 40
> watts of data power output.  The Orion should be set to 100 watts power and
> the Speech Processor should be off.
>
> 73
> Bob, K4TAX
>
>
>
>
> ----- Original Message ----- From: "EI6DL" <ei6dl@eircom.net>
>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, November 14, 2012 3:13 PM
>
> Subject: [TenTec] OrionII and MixW Config settings
>
>
>  Hello ! I have just connected the TenTec Model 712 USB to the Aux/I on my
>> Orion II and ran MixW on my PC .The programme is reading the Digi fsk
>> signals ok but i can not get the programme configed to transmit /send a sig
>> I have the programme set for the TenTec Orion II and have gone into the
>> menu on the Orion II and changed the TX Audio source to Aux instead
>> Mic.Still will not force the transciever to TX a digi sig ?? Can anyone
>> help ? 73'es Tony EI6DL
>> ______________________________**_________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/**mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
>>
>>
>
> ______________________________**_________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/**mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
>



-- 
Stan Brock, WD0BGS
Amateur Radio Sales
Ten-Tec, Inc.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>