Be sure to perform the carrier oscillator alignment (BFO) for SB-N and
SB-R before you do the PBT adjustment.
73,
Barry N1EU
On Fri, Oct 26, 2012 at 5:12 AM, K4MT <k4mt@yahoo.com> wrote:
> My Corsair II has a problem with the PBT adjustment. I can not get the SB-N
> and SB-R to sound the same. When I adjust coil L4 the closest I can get is
> with the slug all the way to the top which raises the frequency f the 15.3012
> crystal. I measured the frequency range of the 15.3012 oscillator and it
> varies from 15.3012 with the PBT control full CW to 15.2969 full CCW, I
> found that SB-R audio quality is very tinny. I was wondering since the
> crystal reads 15.2969 with PBT CCW (no voltage on the varactor) means the
> crystal is too low in frequency. Tentec wants 30 shipped so before I order
> one I was wondering what the experts on this group think.
> I have aligned the carrier oscillators so that is not the problem. It is the
> same on all bands and all crystal filters ( I have 2.4, 1.8, 500 and 250). Do
> you think the 15.3012 crystal is out of specs or is it something with the 2.4
> 9 MHz filter?
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|