[TenTec] Try again, amp

[John Farler <k4avx1@windstream.net>]

The amp put out a good clean up-to-power signal, but did not 
switch back to receive.  The relay locked down in the transmit 
mode, and stays there as long as the amp is turned on.

I suspect something on the control board.  The amp stayed
in xmit mode even without a control connection of either
kind from the the xcvr, as long as the power is on.

I suspect I should look in that area.  Any suggestions
on what to look for?

Thanks, 
73, 
John, K4AVX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec