| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 252M Output Lamp Question |
| From: | "Curt" <rhulett1@consolidated.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 28 Sep 2012 16:38:53 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Thanks to all for the help. After going to RS and finding the #1892 14V
bulb was too large in diameter, I bought an orange LED in 9/32" holder with
pigtails for $2, with integral 680 ohm resistor, nominal 12VDC max 16VDC.
It fit the hole ok and works fine. Not "original" but serves the purpose.
72, Curt _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] 252M Output Lamp Question, Jim Younce |
|---|---|
| Next by Date: | [TenTec] Adding Pilot Light to RX-320D, Richards |
| Previous by Thread: | Re: [TenTec] 252M Output Lamp Question, Jim Younce |
| Next by Thread: | [TenTec] WTB: 250 Hz and 500 Hz Paragon IF filters, PS, Peter Bertini |
| Indexes: | [Date] [Thread] [Top] [All Lists] |