Paul,
I have an Omni VI opt 3 that I purchased used. I have had multiple display
problems. When I opened it up and checked out the display board, it was
obvious that a previous owner had re-soldered things. I cured some problems by
fixing some bad solder joints. And there is a small flaky problem that I
haven't found yet (though the rig is currently on the shelf).
So, I'd suggest doing a good visual inspection of the board... re-solder
carefully...
A second possibility, maybe to try before the other... "exercise" the
connectors on the wiring that goes to that board.
73 & good luck!
Jim, AF3Z
On Aug 25, 2012, at 7:32 PM, Paul A. Ramey wrote:
> While using my radio today I lost all of the segments on the DSP1, right
> side digit. So now I get a read out that is 1 .225, 2 .225 instead of
> 14.225 and 21.225. My computer programs shows the correct freq and I am
> TX/RX on correct freq. Have any of you had this happen? What was the fix?
> Any one have a parts radio that wants to sell a LED display board? I am
> also looking for the following keys that Ten Tec no longer stocks. REV,
> A=B and A/B
>
> Thanks for your help
>
> Paul, WG0G
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|