*Ben,*
* Don't lose hope yet. I have a copy of the schematic. I do however
remember the two electrolytic caps on the input ( red wire ) giving
trouble. one is a 33uf @16 volts and the other 10uf @16volts. My memory is
going but, believe that one or the other have shorted in the past causing
the same problem that you now have. They are C25 and C24 ( If the board is
labeled ) If needed, I will drag out my old flat bed scanner and do my best
to get you a copy of the PA section. While you are in there, replace the 2
caps anyway. Temp rating 105c and higher voltage. *
* 73 de
Wade/KJ4WS*
On Sat, Jul 14, 2012 at 8:09 AM, Ben Hall <kd5byb@kd5byb.net> wrote:
> Hi Wade,
>
> Thanks for posting that - I had a copy from somewhere, but couldn't
> remember where! Bet I got it from QSL.net. Bookmarking it this time,
> heh heh heh.
>
> thanks,
> ben, kd5byb
>
> On 7/14/2012 7:49 AM, wade staggs wrote:
> > *Probably will not help with the repair but, here is a .pdf that you may
> or
> > may not have.*
> > **http://www.qsl.net/tentec/manuals/585.pdf
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|