Re: [TenTec] rx 366

[John Molenda <cdistflatfoot@gmail.com>]

On 6/4/2012 3:38 PM, Carl Moreschi wrote:
> Yes, that is correct.  My N4PY Orion software has a setup to run the 366
> as VFO A for Panadpater use.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 6/4/2012 1:46 PM, John Molenda wrote:
> > On 6/4/2012 5:47 AM, Barry N1EU wrote:
> > > No on both counts.  I believe the 9Mhz out uses the existing "spare"
> > > connector and a pluggable jumper between RX366 and that connector.
> > >
> > > 73,
> > > Barry N1EU
> > >
> > > On Mon, Jun 4, 2012 at 1:44 AM, John Molenda<cdistflatfoot@gmail.com>    wrote:
> > > > Hello, I would like to know if the new Rx 366 board mod takes away
> > > > general coverage receive from the radio.  Does the radio need to be sent
> > > > back to TT for the 9 Megahertz out jack mod ?  thanks John Molenda
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > OK so if we were to hook up to a pan adapter it would only be reading
> > what is on Rx 2or vfo 2  correct ?
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
Thank you .  I am considering it I just do not want to give general 
coverage.  John kb2huk