On 5/14/2012 6:58 AM, Rick Dougherty NQ4I wrote:
> just a few days ago I fired up two fo them on 20m cw...barefoot...on 14.005
> and 14.030 ...just 25 kcs away from each other into separate antenna
> systems...either could tranmit and would NOT
> hear any noise from the other...now that is AMAZING.
I'll top that!
I have a 3-el SteppIR on a 120 ft tower, and a year or so ago, I added a
second tower and monoband antennas for 20, 15, and 10 The two towers
are about 150 ft apart. My SO2R setup is a pair of K3s driving a pair of
Titan 425s. Soon after getting the second tower going, by accident I
noticed that I had both radios on 20CW, about 50 kHz apart, and the
radios did not hear each other -- no clicks, no phase noise! This is
with 1.5kW output, and both receivers set to copy weak signals --
attenuator off, preamp on! Obviously, it matters where the antennas are
pointed, and in this case, they were pointed to the east coast and the
locations of the towers puts each antenna off the side of the other.
I've since observed similar results on 15M and 10M during contests, and
there are times when I'll have two radios on the same band with antennas
pointed in different directions, one radio calling CQ, the other S&P
(search and pounce) to find multipliers.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|