John,
Does the CAT work from the computer you are using to the Orion? If
not, I suggest you check that it does before going back to the update.
Bob G3ORY
>----Original Message----
>From: jrsimon@ozemail.com.au
>Date: 25/04/2012 6:55
>To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
>Subj: [TenTec] Orion566 updating
>
>I've been trying to update my OII from 2.044a to 3.029 using
an RS232-USB
>cable and the radio can't/won't recognise the computer is connected.
I've
>tried two computers, Win 7 and WIN XP.
>
>Holding User 2 and switching on as per the manual until "FLASH UPDATE
MODE"
>is showing, on release of User 2 button the radio then shows "Press
any key
>to Exit".
>I've tried two different RS232-USB cables with the same result.
>
>I've even tried speaking to it in a foreign language that is full of
>four-letter words but still nothing.
>Aside from test flying the OII out the window, any suggestions?
>
>
>
>
>John de VK2XGJ
>You're all jealous because the voices
>only speak to me!
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|