Doc et al,
I just went back and found this in the manual (I've been known to miss things
that were right under my nose before HI HI!!)
>From page 2-5:
"For accurate calibration across all bands, Model 206-A Crystal Calibrator can
be inserted into the antenna line to provide check points every 25 kHz. Its
signal is pulsed for easy identification."
As the younger folks would say, "Well DUUUHHHH...."
TNX/73, Al
On Mon April 23 2012 3:54:54 pm Wilford D Lindsey wrote:
> Al:
>
> Would you please do me (at least!) A favour and share any responses you
> receive to this question? I am wondering exactly the same thing. TIA.
>
> 73,
> Doc/K0EVZ
>
>
> Sent from my Verizon Wireless BlackBerry
>
> -----Original Message-----
> From: Al Gulseth <wb5jnc@centurytel.net>
> Sender: tentec-bounces@contesting.com
> Date: Mon, 23 Apr 2012 12:31:05
> To: <TenTec@contesting.com>
> Reply-To: wb5jnc@centurytel.net,
> Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: [TenTec] Calibrator hookup for 515?
>
> Greetings,
>
> I'm in need of a schematic/info on the 206A (or simply, how/where to feed a
> calibrator into the 515, and at what level.) The only possibility I've come
> up with so far is on the "defeat" (pin 3) of the Molex connector, which
> goes to gate 2 of Q1 on the 80262 front end board. Is this correct, or does
> it tie in somewhere else? (I had thought of using a small whip antenna but
> that's obviously not the way the 206A was connected!)
>
> TNX/73, Al
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|