On Sat, Apr 14, 2012 at 9:19 AM, Rick - DJ0IP / NJ0IP <Rick@dj0ip.de> wrote:
> Thus dual conversion (as referred to in the past 40 years) and as seen in
> the Omni VI, with 9MHz and 5MHz IF frequencies, was actually triple
> conversion, because the signal still gets converted to audio.
>
>
Yeah, but the Omni VI really goes RF - 9Mhz - 6.3Mhz - 9Mhz - audio, so
that would make it quadruple conversion. Don't forget that conversion back
to 9Mhz before the signal leaves the PBT board and goes on to the product
detector.
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|