Scott,
It would work in the Orion, but there really is no advantage to using it
since there is the Inrad 600 Hz filter that replaced the original 1kHz.
There
was some discussion several years back on this reflector comparing both
filters and the consensus was the IMD was better with the Inrad. I found
that the noise floor seemed to be higher when switching the 500 in/out
compared to the 600...might just be me.
I found that after installing the Inrad, I never used a bandwidth lower than
350 Hz, so I removed the 500 and 250 filters that I got from TT. The
250 went into my Omni 6+, but I still don't use it much.
Up to you if you would like to try it.
Hope you are enjoying the Orion.
73,
Robb
-----Original Message-----
From: Scott Weiss
Sent: Friday, April 06, 2012 11:21 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] FS: 500 Hz CW filter
Robb.
Will this filter work in the Orion I?
Scott N2WF
Sent from my iPhone
On Apr 5, 2012, at 10:40 PM, "Robb Urie" <rurie@mywdo.com> wrote:
> Hello,
>
> I have a Ten Tec filter for sale: Model 217 500 Hz $ 65 shipped.
> USPS money order, no Pay Pal, or overseas shipping.
>
> Thanks,
> Robb N0RU
> Woodland Park, CO
>
> rurie@mywdo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|