| To: | Discussion of Ten-Tec Equipment <TenTec@contesting.com> |
|---|---|
| Subject: | [TenTec] Using Aux power and "spare" functions on Argosy 525 |
| From: | Stephen Roberts <steverob@shoreham.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 5 Apr 2012 15:50:41 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Ok, call me stupid but I'm new to all of this. I have an Argosy 525 and I want to run some other stuff from the 12V out on the back of the rig, but when I put a meter on it, it doesn't show any voltage. The Tech manual wasn't much use either. Ideally I'd like to have Powerpole connectors in the back of the rig so I can plug other stuff into it like my audio SCAF filter, antenna tuner, etc. I'm also wondering what the "spare" RCA jacks are for. 73 Steve KB1WUD _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Argosy current draw, Mike Bryce |
|---|---|
| Next by Date: | Re: [TenTec] Argosy current draw, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | [TenTec] Looking for EAGLE will swap HERCULES II..., David Perrin |
| Next by Thread: | Re: [TenTec] Using Aux power and "spare" functions on Argosy 525, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |