This happened to mine. I fixed it by pulling really hard on the AF/RF knob.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 4/2/2012 9:14 PM, Richards wrote:
> Gee, no. That would really suck.
>
> Have you tried re-installing the firmware, from a fresh copy, and then
> do a master re-set ? Maybe even loading up a previous firmware
> version... Nope, this is not logic, but just something that sometimes
> works.
>
> I don't think you have anything to lose.
>
> Good luck.
>
> No need to go off line with answers, as this sort of help
> is what guys do here ! Nothing more topical here than
> a call for technical help.
>
>
> ==================== James -K8JHR =============
>
> On 4/1/2012 2:38 PM, jliving39@comcast.net wrote:
>>
> Mine is stuck in the AF mode. It was originally stuck in the RF
> mode until I did a master reset then it went to the AF mode and is stuck
> there. Any ideas.
> ____________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|