Thanks Barry !
73 Simone
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 22, 2012 10:43 PM
Subject: Re: [TenTec] Orion 565 anv V2 Mods
> Just push the sweep button - if you see a Sweep appear on the bottom of
> the
> display, that again confirms you have the mod installed
>
> Barry N1EU
>
> On Thu, Mar 22, 2012 at 9:41 PM, Simone <it5tntweb@aliceposta.it> wrote:
>
>> hi,
>> i have a 565 with V3 firmware installed
>> but i do not know if the V2 hardware mods
>> are done on this orion.
>>
>> How to know without open the radio if v2 hardware are installed?
>>
>> Pressing menus i can see the firmare and dsp version
>> and " V2 mods confirmed".
>>
>> Thanks
>>
>> 73 Simone IZ5DKJ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|