[TenTec] Corsair II RF Gain Problem

[Russ Straate <rstraate@gmail.com>]

Group.  Thanks for the feedback on the RF Gain.  It appears I have a
problem with my rig.  The RF gain only operates over a very narrow range
when rotating the control.  At about the 6 marking on the dial, the signal
disappears.  The receiver appears to be fine with when wide open so it does
not appear that the receiver level is low.  I have checked the pot with the
wires disconnected an it shows the 10K ohm range as it should.  Any
thoughts on where else I should look?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec