TenTec
[Top] [All Lists]

Re: [TenTec] no transmitt

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] no transmitt
From: wade staggs <tvman1954@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 20 Mar 2012 01:17:32 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Should have been Presence of High SWR.

On Mon, Mar 19, 2012 at 10:00 PM, wade staggs <tvman1954@gmail.com> wrote:

> Don't have an Orion but my Paragon does Strange things like that when the
> Power Supply voltage goes under about 12.5 volts. Also, have had the radio
> go Crazy in the presents of High SWR and also anytime there is Too Much RF
> running around the shack. You may want to monitor your Power Supply Voltage
> to make sure the voltage drop is not too great. Clean the Power Plug and
> Connector. I would also suggest that you double check your Ground
> Connection. Check/Tighten all Coax Connections. My hope is that I have
> helped you out in some way.
>
> Wade/KJ4WS
>
> On Mon, Mar 19, 2012 at 5:15 PM, Rodney <w3krq@dejazzd.com> wrote:
>
>> I turn on orion11 receive ok   I try to transmitt no output led blonks
>> output meter goes up with voice but no rf output this has happen before. I
>> turn off and back on it then works ok.Anyone know what going on.
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>