[TenTec] 3.028 off frequency on 40 meter LSB TX

["Chris Hinson" <chinson1@mindspring.com>]

Since updating my 566 to 3.028 firmware I have told my TX frequency is 20 
cycles low when operating voice on LSB. and I also have not been receiving the 
good audio reports .
I confirmed this talking to a operator using his 566 running the 3,028 on 40 
meters LSB yesterday
and I had to adjust the RIT to +20 to dial him in.
He has also been told that his TX is low and his audio is not as good.
Has anyone else noticed this with their 566 running the 3.028 firmware?
I sent Ten-Tec a email asking their opinion.
73, Chris K4osk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec