It looks like we've just defined one of the first changes for the O3.
Yes, if you want to have separate control of RX1 RF gain and RX2 RF gain,
then you would have to do it twice.
If they don't need to be separate, there has to be a place they share in
common before splitting in two directions, and you could insert it there.
It would then work for both.
73
Rick, DJ0IP
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Barry N1EU
Sent: Friday, February 24, 2012 1:37 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion - Ver. 3.30 / RF GAIN
It seems like an easier fix would be a firmware option to swap AF Gain and
RF Gain controls, although that's out of our control.
Barry N1EU
On Fri, Feb 24, 2012 at 12:35 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
>
> On Fri, Feb 24, 2012 at 12:13 PM, Rick - DJ0IP / NJ0IP
<Rick@dj0ip.de>wrote:
>
>> Normally the Attenuator has nothing to do with the RX ANT jack.
>> It is in the line coming from the TR relay and going to the RX input.
>>
>> What I mean is cut this cable and splice in an external attenuator.
>>
>>
> Yes, that's what I didn't understand - the part about cutting the
> internal cable and bringing it out to the external attenuator. And if
> you use the subrx, you need to do this X 2.
>
> Barry N1EU
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|