On 2/23/2012 4:42 PM, Mike Bryce wrote:
> John,
>
> As goofy as it sounds, the ALC can be affected by the SWR of the antenna. Try
> using a dummy load and see if the ALC blinks with voice peaks.
>
> It's not at all uncommon for a ten tec rig to go into over current protection
> and never light the ALC indicator.
>
> Mike wb8vge
>
> Sent from my iPhone
>
> On Feb 23, 2012, at 3:16 PM, John Molenda<cdistflatfoot@gmail.com> wrote:
>
>> Hello all , new Eagle here . I followed directions to get on SSB and I
>> can not get the alc light to flicker on voice peaks even with the mic
>> gain turned up all the way . am using supplied TT hand mic . John kb2huk
>>
>>
>> BTW the rx is so nice and quiet , great rig .
>> _______________________________________________
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
I just turned on the rig and tried transmitting into a dummy load the
mic worked then tried it on the air and it works there as well go figure
? JOhn kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|