Gary, the 243 is the wrong radio and the wrong manual.
That's for the old Triton, which was different.
It had the Octal Jack on the back and indeed pins 6, 7, and 8 were for the
VFO.
Mike has an Omni C.
It has a 9-Pin Molex accessory socket on the back and totally different
signals on it than the 243's accessory jack.
I have a hard copy manual for OMNI A and D on my desk.
I have the downloaded OMNI C on my screen.
Both are identical and Mike (Brice) already posted the signals that are on
it.
There is NO JUMPER required for the VFO management.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of GARY HUBER
Sent: Tuesday, February 21, 2012 1:30 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C
Download the 243 manual for the pinout and clues....
-----Original Message-----
From: Rick - DJ0IP / NJ0IP
Sent: Tuesday, February 21, 2012 1:36 AM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Omni C
PIN 2 is "T"
PIN 6 is "C1" ("common" of the spst relay)
There is no jumper required.
There is no VFO signal or connection on that jack which needs to be enabled
or disabled.
It would be nice if there were, but unfortunately the problem is elsewhere.
73
Rick, DJ0P
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of GARY HUBER
Sent: Tuesday, February 21, 2012 5:16 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C
What are socket pins 2 and 6 ?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|