Bill-
I have two Rascals and have been using them with Ten Tec rigs for years.
I currently use one with an Omni VI on AFSK. The "Mic In" plug is green
and was labeled when I received it with a felt tip pin. The other plug
is black, unlabeled, and plugged into the Line Out jack. I suspect that
their plug colors are not standardized.
The other Rascal, as I received it from Buxcom, ran "inverted" on FSK. I
opened the unit and attached a 1K resistor to the base of the
transistor. This attaches to a wire that is plugged into the FSK jack on
the back of the Omni VI and Orion. That worked fine until recently, but
something must have come loose in what I did because it quit working. So
I'm on AFSK with the stock Rascal until I get around to fixing the
other. But AFSK with the Rascal works fine.
Hope this helps. Rascals are inexpensive and it shows.
Jim N4AL
n4al@arrl.net
On 2/14/2012 2:00 PM, tentec-request@contesting.com wrote:
> Date: Mon, 13 Feb 2012 14:23:59 -0600
> From:n3wd@n3wd.com
> Subject: [TenTec] Omni VI and Bux Com
> To:<tentec@contesting.com>
> Message-ID:<57275e07ba95c25931378c18c5abbca4@n3wd.com>
> Content-Type: text/plain; charset=UTF-8; format=flowed
>
> Does anyone have the set up configuration to hook up a Buxcom rascal
> and the Omni VI. Need to know where to hook the Black, Red, White and
> Yellow RCS plugs on the back of the Omni VI
>
> Bill, N3WD
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|