On 2/6/2012 10:42 PM, Rick - DJ0IP / NJ0IP wrote:
> On the older manual, it's on page 33:
>
>
> MASTER RESET
> On rare occasions, it may be possible to
> confuse the microprocessor in the
> transceiver to the point where a master reset
> may be necessary to restore operating state.
> A master reset often needs to be done after
> an upgrade for the transceiver is sent via the
> serial port interface (see UPDATING OMNIVII
> FIRMWARE elsewhere in this section).
>
> To perform a master reset, turn transceiver
> power off. Press and hold the MNU button
> down. Turn transceiver power on, and
> continue to hold the MNU button until the
> message "MASTER RESET" appears
> towards the upper left of the radio screen.
> This should take about 5 seconds after
> turning radio power on
>
> 73
> Rick, DJ0IP
>
> Tip:
> * Download an online version;
> * open the file;
> * typein:<CTRL>F (this opens a little search window on the screen)
> * type in: Reset and hit<ENTER?
>
> It searches the file (manual) and finds the spot immediately.
>
> 73
> Rick, DJ0IP
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of John Molenda
> Sent: Tuesday, February 07, 2012 3:00 AM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] quick help
>
> can anyone tell me the reset procedure with the omni vII can't find
> manual . thanks John kb2huk
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
Thanks Rick that reset seems to fixed the problem . I appreciate the
quick help . John kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|