Sorry, sent the message before I added the title... Now, it will appear in
the proper thread.
On Sat, Feb 4, 2012 at 9:26 PM, John Henry <jhenry@tentec.com> wrote:
> The 9MHz IF Output on the RX366 is the TMP connector on the TXRX board
> (The board with the filters), right next to the F2 filter.
> If you are going to use an LP-PAN, you should use the preamp offered by
> telepost.
> We are modifying the user manual to point out it's location in a picture.
> Should be available for download in a few days.
>
> Good luck,
> John
> ------------------------
>
> My RX366 arrived via USPS this Saturday afternoon - installed it and it seems
> to work FB!
> I need info about which TMP jack on the RX366 board is the IF out for the
> panadapter -
> I plan on using the SPARE RCA jack on the back of my Orion 565 - I have a
> TMP cable
> ready to go - just need the ID of the jack on the RX366 board and confirm
> that the empty
> TMP jack on back panel is the connection to the SPARE RCA jack.
>
> I have my LP-PAN and N4PY and PowerSDR-IF software ready to go.
>
> Terry Zivney, N4TZ
> N4TZ at ARRL.NET
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|